Wavy Metal Roof

A layer of felt paper acts as a base and goes down before the shingles for every installation.

Wavy metal roof.

A roof with a wavy look to it can be caused by a number of reasons but the problem may be short lived. However that pronounced wave will nearly always signify one big thing. Is your roof new. If you have more question or concerns about your wavy or warped roof and would like a professional consultation contact us at schroer and sons.

Let s go into some more detail to give you a better idea. Rafters if too far apart may result in the plywood sagging or if the plywood is too thin for the weight it may sag. Corrugated panels are connected by overlapping the sheets and then securing them in place with exposed fasteners. Wavy roofs are not normal and they do not happen on their own naturally.

Wavy or warped roofs don t happen naturally. There are several reasons for a wavy looking roof. So what are some of the reasons your roof can look wavy. Having wet or poorly placed felt paper under your shingles can cause your roof to be wavy.

Let s take a look at some of the typical causes of a wavy shingles especially after a new roof is installed. Steel aluminum zinc or copper. There are a few reasons why it occurs but please remember that it is dangerous for you to attempt to diy or self inspect your roof. Causes of a wavy roof.

These panels can be used for roofing siding decking and flooring. In technical terms oil canning is referred to as elastic buckling more commonly known as stress wrinkling. The shingles may look wavy right. If the material was.

This type of roof wave is usually only seen after a new installation. Poor framing practice is one of the more common reasons for roof waviness. It was the first mass produced metal panel design in the united states. If you have recently had a roof installed and it has started to look wavy there are the possibilities.

The carpenter may have failed to put all of the crowns up on site framed roofs. Rather rely on a local roofing contractor for professional help. It can occur in any type of metal panel. If your new roof was laid over an old layer of roofing this could cause.

A wavy roof is rather alarming and unfortunately there are actually quite a few potential causes. Some of these can include a warped foundation damaged underlayment distortion from heat or even bad workmanship of the roofers. When some of the crowns are up and some are down then the roof has a wavy look but it is still structurally sound. Thankfully this is usually corrected with a little time and heat.

Your roof is buckling or bulging somewhere or the materials simply aren t lying flat.